|Dimensions||7 × 3 × 1.5 in|
Some people have more difficulty filling the AquaCure through the Tower Cap check valve because of weak or arthritic hands.
Since the Humidifier water must be used to refill the AquaCure (to put trapped lye back into the machine) and the AquaCure must be filled through the check valve (to keep the check valve functional) …
… we’ve developed a ‘pump’ that allows water to easily be sucked out of the Humidifier tank and pushed into the Tower Cap check valve.
IMPORTANT NOTE: You can put the adaptor hose on the check valve permanently and then just stick the pump hose into it when needed.
To use the pump, simply slide the short adaptor hose (1/4″ ID) onto the Tower Cap check valve (water fill).
Then slide the 1/4″ OD hose from the pump into the 1/4″ ID adaptor.
Then put the other hose (the one with the pump check valve) into the Humidifier water tank (after taking the Humidifier lid off, of course).
Remember that the AquaCure should always be topped up (water filled) from the Humidifier Tank. This puts any residual trapped lye back into the AquaCure. It also keeps the check valve ‘washed’ and clean.
TIP: If the 1/4″ adaptor tube is too hard for you to install on the check valve (weak hands), it slides on easier if you soften the plastic by putting one end of it in boiling water.