AquaCure model AC50 Operation Manual

More helpful links:

See Brown’s Gas testimonials / studies / etc. here:
http://eagle-research.life

AquaCure Brochure
https://eagle-research.com/wp-content/uploads/2020/02/AC-Brochure-small-v4generic.pdf

Brown’s Gas for Health (legacy page)
https://eagle-research.com/browns-gas-for-health

What is Brown’s Gas?
https://eagle-research.com/q-what-is-browns-gas-bg/

How I use Brown’s Gas for Health
https://eagle-research.com/how-i-use-browns-gas-for-health-enhancement/

Plants Don’t Lie
https://eagle-research.com/plants-dont-lie/

Purchase your AquaCure model AC50 here:
https://eagle-research.com/product/ac50/

Properly Install the Tower Cap
https://youtu.be/Pr98DMe94No

Make sure your Tower Cap base Union is sealed properly and that you remove the Tower Cap using the Union ring, so you do not need to keep re-applying the Teflon Tape.
DO NOT ’torque’ on the Tower Cap (turn the Tower Cap itself) to seal the base fitting; doing so will ‘lock up’ the Union, requiring wrenches to loosen it.

AquaCure Rinsing Technique
https://youtu.be/oac55WgfIvs

When Rinsing:
To dissolve soap formations you need water in the 120° F to 140°F range.  The water must be hot; warm water does little.  Remember to trade out the hot water within a minute or so (at first) because it will cool quickly as it heats up the components.
You Fill the AquaCure to FULL with HOT water (6 to 7 cups).  Then alternately and SLOWLY lift the front and back of the machine up to 60 degrees to ‘wash’ the HOT water up and down in the Sight Tube.
You need to change out the HOT water frequently because it cools off quickly and warm water does little to dissolve soap.
NOTE: If the HOT water doesn’t ‘’reach’ the tight tube, doesn’t wash’ up and down in the sight tube, it CANNOT clean the sight tube; if you are not getting the water washing up and down in the sight tube, it’s likely due to a plug or restriction and that needs to be fixed ‘manually’; ask for instructions.

Note: I occasionally get an ‘air bubble’ in the tube (so it will seem that the sight tube and/or ball is not ‘registering’ the actual fluid level correctly).
Generally air bubbles will eventually clear on their own, but you can ‘hurry’ the process by filling the AquaCure with solution.  Then alternately and VERY SLOWLY lift the front and back of the machine up to 60 degrees to ‘wash’ the solution up and down in the Sight Tube, washing out the air bubble(s) and the ball should float properly.

Setup your AquaCureAC50 torch attachment:
https://youtu.be/v2ufQWJ0l0Q

H2 Hubb AquaCure AC50,  Unboxing, Setup and Test videos:
Unboxing   https://www.youtube.com/watch?v=i5CAuVYu_a4&t=368s
Setup    https://www.youtube.com/watch?v=PAmDyKdai4Y
Test gas production   https://www.youtube.com/watch?v=w1GOztHEOgk