by | May 8, 2019 | FAQ, HYCO 2A
Ahhhh 🙂 Very good question 🙂 I used to make a HyCO 2A kit when my customers were mostly carbureted. The HyCO 2A didn’t work well on Fuel Injected systems because the MAP Sensor ‘read’ the input as a ‘vacuum leak’ which cause the...
by | May 8, 2019 | Brown's Gas as Torch Fuel, FAQ
Only if you use the ‘air pocket’ technique commonly used with oxy./acet. is used under water and the water depth is not too deep because BG cannot be pressurized too much or it will explode.
by | May 8, 2019 | ER HyZor (Install and Op), FAQ
I recommend 25% lye to water by weight. I understand that may be a little confusing because people ask “Is that 250 grams for 1 liter or 250 grams for 750 CC?” Actually it isn’t that critical and either will work. I usually use the former and the...
by | May 8, 2019 | ER HyZor (Install and Op), FAQ
Usually foam isn’t too much of an issue in a HyZor, so most people don’t even need to worry about it. For those people who worry about it anyway, here’s some tips: Several things cause foam so the best thing to ‘do about it’ is to...
by | May 8, 2019 | EFIE, FAQ
The EFIE Device (and the kit) are designed to deliver less than 500 mV (0.5 Volt) It’s easy to test, just hook the red and black to positive and negative respectively (12 VDC) and measure the voltage across the white and green. I am a mechanic and the original...
by | May 8, 2019 | ER HyZor (General), FAQ
A. Brown’s Gas makes the engine more efficient and ‘longer lived’ in several ways. In this application, BG is like a catalyst; NOT a FUEL! For a PDF that details the catalytic effect (click here). BG’s helps the fuel Burn much faster, during...
