by | May 8, 2019 | ER HyZor (Install and Op), FAQ
A. Yes. If lye is not added as a catalyst the ER HyZor won’t produce gas because pure water has far too high an electrical resistance. Electrolyzers use a catalyst to lower electrical resistance. We’ve tested many catalysts and discovered (for our...
by | May 8, 2019 | FAQ, RYEM
A. That depends on your energy needs and what you choose as a prime mover.
by | May 8, 2019 | FAQ, RYEM
A. Two ways; overdrive the motor (for example, drive a 1760 rpm motor over 1800 and then either… 1. Connect it to an AC sine signal (usually connect to the Grid at 50 or 60 Hz) or… 2. Give the motor a jolt of DC current to ‘excite’ the...
by | May 8, 2019 | CPS, FAQ
With Capacitive Power Supply (CPS) technology, the real wattage is the LOAD amperage and voltage; not the SOURCE amperage and voltage. For a battery charger the ‘load’ is the battery; so you measure the amperage going into your battery and the voltage of...
by | May 8, 2019 | FAQ, HYCO 2A
Ahhhh 🙂 Very good question 🙂 I used to make a HyCO 2A kit when my customers were mostly carbureted. The HyCO 2A didn’t work well on Fuel Injected systems because the MAP Sensor ‘read’ the input as a ‘vacuum leak’ which cause the...
by | May 8, 2019 | Brown's Gas as Torch Fuel, FAQ
Only if you use the ‘air pocket’ technique commonly used with oxy./acet. is used under water and the water depth is not too deep because BG cannot be pressurized too much or it will explode.
by | May 8, 2019 | ER HyZor (Install and Op), FAQ
I recommend 25% lye to water by weight. I understand that may be a little confusing because people ask “Is that 250 grams for 1 liter or 250 grams for 750 CC?” Actually it isn’t that critical and either will work. I usually use the former and the...
by | May 8, 2019 | ER HyZor (Install and Op), FAQ
Usually foam isn’t too much of an issue in a HyZor, so most people don’t even need to worry about it. For those people who worry about it anyway, here’s some tips: Several things cause foam so the best thing to ‘do about it’ is to...
by | May 8, 2019 | EFIE, FAQ
The EFIE Device (and the kit) are designed to deliver less than 500 mV (0.5 Volt) It’s easy to test, just hook the red and black to positive and negative respectively (12 VDC) and measure the voltage across the white and green. I am a mechanic and the original...
by | May 8, 2019 | ER HyZor (Other), FAQ
A. Eagle-Research does not recommend storing Brown’s Gas in any kind of tank. BG is primarily a stoichiometric mixture of hydrogen and oxygen; one of the most explosive mixtures known! If you watch the movie ‘Outbreak’ you will see two examples of...
